0 prece(s) - Zvanīt
Jūsu grozs pagaidām ir tukšs!
Sākums > Pieskārienu jūtīgie ekrāna moduļi > 12V Controller
12V Controller
12V Controller 12V Controller 12V Controller 12V Controller 12V Controller 12V Controller 12V Controller

12V Controller

Artikula Nr.: 12v
Pieejamība: Jāpasūta
Zvanīt
Bez PVN: Zvanīt
Papildu iespējas:

 Skaits:
Pievienot vēlmju sarakstam Pievienot salīdzināšanai

Multi-layer surface-mount design with internal ground plane for EMI suppression

 

  Features
          •the newest controller
          •10ms conversion time 
          •Support size of touchscreens from 6.4" to 22" without jumper setting
          •touch sensitivity can be adjusted in 5 levels
          •Operation temperature from 0ºC to 70ºC

 

Supply Voltage and Current 
+12VDC, normal (+11V to +13VDC)
220mA, typical at +12VDC, Average power consumption is 2.6W.
Supply must be capable of sourcing 350mA, minimum.
Total noise and ripple requirement must be less than 100mV (p-p) for frequencies below 1 MHz, 
and less than 50 mV (p-p) for frequencies above 1 MHz.

Interface 
•USB1.1

•EIA 232E (Serial RS-232). DCE configuration, 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex.

Baud Rate (only serial port)
9600

Operation Mode 
Support T and C Mode Protocols Support UP/STREAM/DOWN and Z Axis Modes

Touch Resolution 
4096x4096, size independent, 256 levels of Z axis (pressure)

 

Conversion Time 
Approximately 16 ms per coordinate set (including transmitting time)

Reliability 
MTBF is more than 300,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground 
benign environment with an ambient temperature of 25ºC

Flammability 
The printed circuit board substrate is rated with 94V0.

ESD 
Per EN 61000-4-2: Contact discharge +4kV, air discharge +8KV.

Environmental Temperature 
Operation: controller: 0ºC - 70ºCscreen: -20ºC - 50ºC
Storage: controller: -20ºC - 80ºCscreen: -40ºC - 70ºC

Relative Humidity 
Operating: 10% to 90%, non-condensing
Storage: 10% to 90%, non-condensing